eTec PT-3812 Firmware Upgrade CD
Conexant flash program, error messages

Firmware.dlf file generated
Set size of SDRAM to 8MB

WaitForBlockReady timeout
BUS_IO--> Addr=1 Endpt=1 IN #Bytes=0 NAKreceived Ctrl=008807ff Token=07e08169

Error: Couldn't set SDRAM size!!!

Error: This error will occur if the jumper is not fitted to JP1.

Solution: Make sure you have fitted a jumper that makes good contact to JP1

Firmware.dlf file generated
Set size of SDRAM to 8MB

WaitForBloackReady timeout
BUS_IO--> Addr=1 Endpt=1 OUT #Bytes=1 Ctrl=00800000 Token=07e081e1

Error: Couldn't set clocks!!!

Error: This error seems to be attributed to using the flash program with usb controller's that are not supported.

Solution: Try using an older pc that has a Legacy Intel USB controller, an older Intel chipset motherboard should work fine.